An easily made arrangement is suggested in Fig. 288. The design can easily be varied if you wish.

Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in Part V., and look up any other references.

The construction is extremely simple, the shelves being merely screwed on from the back.

Get out the back and the shelves, and smooth them. Mark lines across the face of the former at the places for the shelves, bore holes through the back from the face for the screws (see Boring), and countersink the holes on the back (see Countersink). Screw the shelves in place (see Screws) to see that everything is right, then take apart and finish.

Fig. 288.

See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in Part V.

Wall-Shelves #2

A quite simple form is shown in Fig. 291, having a small box with lid. A combination of this form with the design for a pipe-rack can easily be made if desired.

Before beginning work read carefully Marking, Rule, Square, Saw, Plane, in Part V., and look up any other references.

The construction is plain from the cases already described. The hinges should be sunk in the edge of the lid (see Hinges).

See end of introduction to this chapter for directions about smoothing, putting together, and finishing. See also Scraper, Sandpaper, and Finishing, in Part V.

Fig. 291.